Elevator Forum

Indirtwetrust
@indirtwetrust
Noble Member
Joined: Jan 1, 2010
Topics: 63 / Replies: 1696
Reply

All you need to do is replace 1 button at a time, press it and it’s programmed. If the whole thing is screwed op now you’ll have to order the programm...

9 months ago
Reply

I’ve copied OMUs with a cheap TL866–II off of Amazon. I’m sure a Dataman can do it. You just have to choose the right chip.

9 months ago
Reply

Because the door squeezes when it gets a call but with no call it just sits on DCL

9 months ago
Reply

You don’t use a tool on a KCM831

9 months ago
Reply

ECI America

9 months ago
Reply

It sounds like the close limit is opening way early

9 months ago
Reply

Con 34 is Port 14Con 35 is Port 15Con 37 is Port 16

10 months ago
Reply

You’ll have to get new job configs to add a CNA card but there are probably enough extra IOs on the IOC card to do it.

10 months ago
Reply

How many stops?

10 months ago
Reply

That’s fine then, it was probably a VH8 anyway. Are these some official looking stickers or label maker labels? Just curious because I’ve never seen a...

12 months ago
Reply

I’ve been waiting to hear back. I thought for sure it was a 16 bit controller with a VH8 IOC card.

12 months ago
Reply

That is baffling… as far as I know the motor encoder should have zero to do with that

12 months ago
Reply

A quick way to rule out an encoder issue on an IMC-AC controller with an F5 drive is to set the drive to open loop (LF.30) and see if it persists.

12 months ago
Reply

I completely agree, this is nonsense. Every concern mentioned (over and over and over) can be mitigated by correct adjustment and good maintenance.

12 months ago
Reply

Yes, the rest 0

1 year ago
Page 3 / 118
Scroll to Top