Elevator Forum

Are you getting MCSS faults?

I think California required an auxiliary door close switch external from the door board. Last edited by Indirtwetrust; 02/16/17 12:31 AM.

Ya I see you do have to do the setup drive. Glad it went well. The upgrade to a KDL16 is pretty smooth too, just have to replace the tach with an enco...

We battled this for months on an HS with the WG operator. That auxiliary close limit was put right on the strike and it was one of those heavy duty pl...

I don't think I even had to re-learn the hoistway when I did that. Could be wrong but it was super easy, just re-enter the parameters. I may have a sh...

BTW, I've never even seen BSLM2 input used before. And I only found that fault in the TAC32-T manual.

The brake switch inputs are susceptible to noise. They should be in shielded cable with the shield grounded on 1 end. You can also wire a resistor fro...

Well is there a separate group controller in the machine room? There is no reason a group dispatcher would need 3 phase 480. That is why most dispatch...

I've seen those on eBay. What all does that do for you? I haven't seen anything about it in any of my KCM manuals.

What are Spider gears?

I think Kone may use the Cetek drive now if you are talking about the obsolete AC drive. We did 2 a couple years ago we got direct from Cetek. No prob...

You can download Hyperterminal for free. I think you just need a 9 to 9 pin Null Modem cable. I haven't got to do it yet but got set up to.

Ya that actually just happened to this machine. It did this for at least 10 years before locking up though. It seemed a little better after they repla...

Does (2003) mean it was put in in 2003 or it's a TAC20-03?You are really going to need IMS to get any further with this.