Elevator Forum

"You can feel it when it arrives and leaves the floor". Sort of a slight racking due to tight packing on one side. Well, short of a repack, which if y...

phil,try this; [email protected]you might need a serial number of any unit when calling. Last edited by elmcannic; 05/11/17 04:49 AM.

Hopefully it's out of your hair for good. This is yet another great example of what the forum is designed to do, and I hope we're not premature in ext...

Me too....

Or-If a Maxton UC4 valve, be sure the F/S adjuster is on the dot/scribe line, and that the three allen bolts are tight. If you increase UL only to hav...

Wow....Well, as was discussed earlier, in the elevator industry we typically use a dedicated landline for emergency phone service. Not that your desir...

You mention checking the magnets and they look fine. But... It doesn't take but maybe 1/16" gap between any two magnets and your description of slow s...

Dan,You're gonna need to communicate with the controller via laptop or whatever plug in tool. How do you know they're "fault" LEDs?

Yes

I believe on the TAC20, the CPU has to see gate lock, door lock and DCL in that sequential order without much delay between the last two inputs. Conve...

If the LN card has a steady heartbeat it's probably ok. Rapid rate indicates LON trouble....somewhere.The L24 cards are easily replaced. On a side not...

Yeah your gonna need a FAST tool. i think the car should run on access on a cold start (dead CLC battery) otherwise you couldn't do a HW scan...I thin...

So...Who makes the best hydro oil?And for the traction machine, the best gear oil?

+1 on Rath. I think that's their phone of choice nowadays.

ALK,Better to leave that button pushing stuff in the controller to a qualified elevator technician, and poking around that 12 volt circuit is gonna ge...