Elevator Forum

My bad...I see you did distinguish between VOIP ups and the lowering system ups.

Just my 2 cents here;One of my customers just went through this VOIP business. The OEM equipment had its own dialer interface module that originally w...

You know what Marvin.....You just might be right!

Is that the red phone that has a 9 volt battery inside? When the battery depletes, the phone won't dial out although the phone line is good. Learned t...

The I-2 valve is a pretty good valve on my opinion. The one trouble that'll kick your butt around the block is the up level adjuster. Intermittent ent...

Heres a shot...Bad leveling inductor?

Check to see if both cars are master. One has to be slave car.

Did you replace the Siemans starter too? I ask because yes we have had that happen on a Thyssen hydro. It boiled the oil, ruined the valve, and if I r...

My experience is that the torque is factory set at maximum, 30lbs. It's a pain to check too as the door edge fires a reopen every time you get your ga...

It's been a while, but we used to solder a wire from the power supply +5 volts to the TV+5 terminal. Maybe you meant " HRV" ( hall riser voltage) whic...

And...Do you have the PCD tool or any other diagnostic tool to see the computer signals?

My thought is;Is the DZ relay replaceable on the Function Board? What is it that this elevator is not doing properly? Last edited by elmcannic; 12/...

Just out of curiosity...What is a 48 fault?

And....If the scan fails, the set up window tells you so. 10025 is typically bottom floor. So...if your not incrementing your count, you may want to c...

Hi Jacques,Well, I'm no electrical engineer or programmer, but I would imagine at the very least and electrical engineer would need be employed, and o...