Elevator Forum

Otis 211 w/ at400 d...
 
Notifications
Clear all

Otis 211 w/ at400 door operator

10 Posts
6 Users
0 Reactions
21.5 K Views
(@getemup)
Eminent Member
Joined: 17 years ago
Posts: 22
Topic starter   [#17361]
Working on a Otis 211 with the at400 door operator and was wondering if you are able to turn down the nudging force and the closing force.



   
Quote
(@magic-smoke)
Trusted Member
Joined: 17 years ago
Posts: 68

   
ReplyQuote
(@indirtwetrust)
Noble Member
Joined: 17 years ago
Posts: 1759

   
ReplyQuote
(@getemup)
Eminent Member
Joined: 17 years ago
Posts: 22
Topic starter  
Did the learn run, but still maxing out my door gauge. Can you hook up the tool up to the port on the operator or is it through the controller.



   
ReplyQuote
(@indirtwetrust)
Noble Member
Joined: 17 years ago
Posts: 1759

   
ReplyQuote
(@magic-smoke)
Trusted Member
Joined: 17 years ago
Posts: 68
 
Thru the door operator. Don't believe you can change force item or profile from controller.

some of the at400 had to have a software upgrade to correct this problem. Door would torque up after a stall and exceed max allowed force. The black belt operator had the same problem.



   
ReplyQuote
(@getemup)
Eminent Member
Joined: 17 years ago
Posts: 22
Topic starter  
Thanks guy's, changed out the at400 door operator with new and now not maxing out my gauge but still is pushing the code maximum, but stable at 30 on the closing and nudging force.



   
ReplyQuote
(@peter-iuec)
Active Member
Joined: 17 years ago
Posts: 14
 
You can adjust nudging close force as low as 80 if you have a service tool. Another way is to make some other changes that make it reenergize in the open direction. If you would like PM me and I can help you.



   
ReplyQuote
(@elmcannic)
Honorable Member
Joined: 17 years ago
Posts: 635
 
My experience is that the torque is factory set at maximum, 30lbs. It's a pain to check too as the door edge fires a reopen every time you get your gauge near it.
My experiment was to slow high speed down to get less torque, but then door close time was affected and a nudge buzzer would turn on near full close which generated reduced speed and ROA call backs. Reverted to original parameters.
Maybe Green Pants will chime in to tell us what the answer may be.



   
ReplyQuote
 Len
(@len)
Estimable Member
Joined: 17 years ago
Posts: 194

   
ReplyQuote
Share:
Scroll to Top