Elevator Forum

Add GAL to the list of controllers they are out of New York and we have installed about 30 units of theirs and about 40 units with Motion Control.All ...

I would recheck the switches and see if you are trying to make or break a switch at the spot you are shutting down. The old method of disconnecting ca...

I had a Westinghoue with AC on the DC side one time after replacing the rectifier I still the same problem. Then it dawned on me and I disconected the...

halfpick--yes thats the one just older. We got some adjustment proceadures from KEB. But if no one elce has seen this set up it looks like we got a fa...

Looks like it came straight from the factory. Castings are in place but were never drilled. Personally i would never put a disc brake on an elevator. ...

I too can not find a CLC #8. But I did find CLC timer #8 for PI Timeout......We have backed up all our DMC onto floppy disk. One in the shop one on th...

Do a search on this and you will find alot of good info from earler posts.

A true leader that we all owe a dept of gratitude. God bless him and his family.

Marbles, Without a print in front of me I dont remember the contact. But you should have a contact that keeps you from seeing your leveling contacts w...

Yes but the best part was asking thru the doors. ARE YOU SURE YOUR STUCK HE HE HE HE......And both of you knowing he cant tell you what an A hole you ...

I have seen and tried these units at the elevator convention. They are slow but safe. Very JETTSONS with the clear tube. They have units big enough fo...

Len thanks for the heads up on the software. Looks like the new mag reader switches did the trick. We replaced them all and reset them to 1/8 off magn...