Elevator Forum

We will only use Texacone supream green packings do to similar problems

X3 on Cat Juice and Cat juice only we had a job went thru the same problems and were adding another brand. Finally used Cat jucice all fine now.

An easy way to check your feilds is to unhook them from the controller and then use machine room 110vac to power them up. Then take voltage reading ac...

Is the guy on standby over the aweekend a suckass because he was on standby or because he didnt fix the elevator? Call back burnout is a broblem in ou...

Scott is right you can find out why and repair the problem to get each port working. I have seen where people think they have a problem with their wor...

If you have an older version of World and your elevator has security keyswitched , card reader or keypad you may have a problem as the older World wou...

Ok we finally got to see the problem and do it repeatedly. Turns out the input board rack was bad and we wernt getting LRD thru the rack. Changed out ...

Yes. And then duct tape or the really big zip ties to hold them in place. The bed sheets let the air thru so you dont end up with a big baloon on your...

The operators are Mac that have been updated to the 104 board. But it sound like I got my answer this is a know problem with this vintage.

Dont give up on blowing out motors and gen sets. If you dont the motor shop will end up with them anyway. We use a large fan and bed sheets to control...

We can make all 10 open the doors without being in a door zone by stoping the car with the safety string or loss of normal run. Opening interlock will...

If parts are not the problem then what seems to be? We have alot of these units that run with only a couple calls a year and some of those calls are d...

We no longer have any 1200 stuff but still have several 1220 and 1230 units. So I am always looking for boards. On the 1220 stuff we use to solder wir...

The 1230 were Hydo controllers so that may be why they dont work so hot on traction machines.