Elevator Forum

i agree with Bowtierooster after checking 100s of cars hydo car weight is a couple hundred pounds shy of capacity. Holds true for traction cars as wel...

ive seen 3 different times where people were dipping oil out of tank for their skid steer or tractor. but ive seen lots of times oil was leaking from ...

What do you do to make it work again? Have you replaced the ziner dioeds on top? I would be looking for a possible resistor getting hot and opening. H...

We need a close up of controller tag

You should be fine.

Check your PMs

Most controller manufacturers will sell a dispatch panel that will send calls to the old and new controllers and cancel the call when a car arrives. I...

We found adjusting governor pull thru changed the slide more than anything you can adjust on the safety. I would suggest a dry powder like line chalk ...

High speed Down contact not making. This will be the contact that keeps you from slowing down and stopping . Could be a bad shunt on the contact.

EElevator has good advice. Check motor wiring and motor to pump connection we had a lose one hake lots of noise. If its a air up muffler that can be y...

Before I put a new T cable on I would swap my door operator wires with other adjacent wires and see if that fixes the problem. Or creates a new proble...

did you replace starter with pump unit? Maybe to a soft start?

Jim collette passed away several years ago. He had amassed a huge library spanning over 100 years of elevators, escalators. platform lifts and dumb wa...

Dirt send an email to [email protected] I have 1968 and 1970 prints

I’m not a fan of air bladder silencers. Not only have you added maintenance tasks and another point of failure we have had to replace several already....