Elevator Forum

possibly looking at this wrong way. Majority of times I've had the button bases crack and cause this same thing.

I use Stannah (Sterling Stairlift). They have been the most reliable, best fitting, best support system of the ones we used.Mostly my customers have b...

sounds like not programmed for proper fire service

My mistake, I did not pay attention. I assumed being a 2 stop it was a DMC 1A, the other limits can fail also but I've only had the springs go on the ...

Very easy to check. By hand push the roller, if tension is off at all, the spring steel is getting weak and probably about to break. I've ordered just...

I'm not sure, but I think it's in their program. They'll act like duplex until high demand.

check spring steel on the limits, they get weak and give intermittent troubles.

For category 1 tests, if wp is known, we run into stop ring to check system pressure and relief. If unknown we load capacity to get it.

I have installed and serviced Concord (pre Savaria) LULAs, they're a good unit. But, I agree if looking elsewhere Canton is tried and true.

I would change the board to the 104 board. Do a google search for konespares,click on MAC door equipment,scroll down the downloads till solid state co...

Did not think right. You can download info from Kone Spares

I agree with uppo72. The adjusting is the same with the different versions, but need to know if you have the 104 board or earlier version. I have manu...

Might sound stupid, but check the ground wire from gen.

Not familiar with Shepards, but commonly find the aux. contacts not making on first contactor.