Elevator Forum

either the valve is not adjusted properly or it is bad. The viscocity control sounds to be working properly

not an option at this job. Sills not worn thru (other comapny turned tab out and it was hitting sill), we're going to try and take edge off of groove....

Thanks solidstate, I thought of just about everyone else but could'nt remember them.

I've had inspectors in our area make us prove they are functional if they are on the job. If you disconnect them I suggest getting them off the job.

BrianW, You may be able to find contacts for it but I believe they have been discontinued years ago.

sorry, christycollett. The only print I found was not the one. I'll keep my eyes open. Good luck, may hafta troubleshoot by common sense and draw it d...

Not to get you guys fired up, just because they are non-union doesn't make them incompetant. Many non-union shops come from and have people that were ...

Sorry I think I'm answering this on your other post, forget where I'm at sometimes.

WorkingSuper,I'm not trying to insult you, trying to assist. Yes, to diagnose correctly someone would need to be on job site, otherwise everyone is ju...

Agree with john jay, a competent elevator company should be able to troubleshoot your problem and come up with a solution. I don't have enough info to...

I know your getting different answers from them, but go with the proffesionals. To many factors to consider here without knowing more about the equipm...

I'm assuming your not an elevator contractor by your description, most elevator men use different terminology. To answer your question, it's always a ...

You should'nt use WD40, just like door rollers, it will cause premature wearing out. I had a triplex on route for years, carbon dust everyware, caused...

I've had one very similar to this on service back in the eighties if memory serves. I may have prints somewhere back in the shop. Be easier if could r...