Elevator Forum

We have a 1st out and a second out. They decide who takes what, but at least you have 2 to cover. To help with the fatigue they are on a 2 day rotatio...

Glad you passed. Now learn everything you can with the mechanics you work with. Then at home learn even more from literature. But hands on will be the...

Door close power. Closing force picks up clutch.

Then you have a bad board or Hyperterminal is not setup right.

You have to upload software with Hyper Terminal. Will that not connect? IMS will not till you upload the needed files.

Check your 24v power supply.

There are always negatives in any trade. And many might very from company to company, individual to individual, and especially department to departmen...

I agree with everything pdq just said. But if its a single stage jack then Jack Resync should not be enabled. If it is, you would need IMS to disable.

No, if you have a UIT then go to Commands and issue a STU command. But if you are referring to the selector by the tapehead I think the hoistway scan ...

Yes, if you have the office version of IMS you can.

PM sent.

I think I've found the best flashlight for our industry. Short of being all metal. Has several modes, side light, and magnetic back. I use mine every ...

Check for 120Vac on terminals 1 and 3 on the starter after powering up or a reset. A tac20 will power it up after about 20 or so seconds. Then some fa...

I believe P24 ties to board in different locations. Make sure you have P24.