Elevator Forum

DM sent...

It’s the way the industry is going. What is the job #?

PM me. I can take care of you.

Have you reloaded the software? Like Dirt said?

Is it a 188e board? is so then it could have LON. But if the 188e has the large ribbon cable plugged into the left side of the 188e board then its a T...

I agree the correct config is the best. But many people have the config backed up.

Like Dirt said, there is no LON on a TAC 20-03. But the 1083 error could be corrected with a fresh software upload so I would try that first. And even...

You can. If you have the wiring diagrams with all your I/O's. then you can make the configuration correct. What is the Job number?

What 20 fault? If it's 20-002 it might be that the floors were not validated correctly. If it's a 3 stop front only parameters 52 and 56 should be 7. ...

Welcome

Depends on if it is a Simplex or Duplex. Attachments Can 1.png (85.84 KB, 24 downloads)

Try this.https://drive.google.com/file/d/1rnbo0T2bcHh7VX5AB-8ey6h5eCcfdiZD/view?usp=sharing

Try these. https://drive.google.com/file/d/12XYLcP8YVGu73icqyTAcpELg9uJEnVJN/view?usp=sharingThey are all I have so if someone has any more for 3300 o...