Elevator Forum

uppo72
@uppo72
Honorable Member
Joined: Jan 1, 2010
Topics: 5 / Replies: 557
Reply

Is it a serial data lift? If not just change the buttons and be done with it.

12 years ago
Reply

R.I.P and c's to family and friends.

12 years ago
Reply

Does this noise only operate in the up direction when the pump is going? Try to separate which valve may be oscillating or radiating noise. Is this a ...

12 years ago
Reply

Originally Posted By: Chris Sorry about the confusion, but I finally got to the job yesterday. I don't have time this morning to go into much detail, ...

12 years ago
Reply

Originally Posted By: jkh Scott,Thanks for sharing that story. I have a university that have two MCE units with DBRs. I'm emailing them your backup ge...

12 years ago
Reply

Originally Posted By: sbrmilitia Any explanation yet on what caused this?Since it was a two speed side slip did the slow door come unrelated? I take...

12 years ago
Reply

Originally Posted By: Chris Thanks for the reply. Are the slow down distances set similar to GAL? 1st at 3/4 of open distance then 2nd at the last 4 i...

12 years ago
Reply

Originally Posted By: rollaway-up Had in car pushbutton not working (placing a car call) on an LRV 3. Didn't have a replacement board handy so i swapp...

12 years ago
Reply

Originally Posted By: sbrmilitia I took a late night call last year and I had to turn the disconnect off. The coil was open on the 1MA contactor. I tu...

12 years ago
Forum
Reply

Originally Posted By: Postal Power surges ,misuse and abuse(not tge case here) and other acts of god are very very very seldomly covered by many maint...

12 years ago
Reply

This sounds like the over current has blown the control pcb of the lift. It could be a software or hardware issue. Most of the time, the mechanic just...

12 years ago
Reply

The best lesson I ever learnt was when fault finding, particularly in the relay logic age, was the best tool to fix lifts was your eyes. Understand yo...

12 years ago
Reply

By calling this a floor controller and not a selector, this sounds like its coming from a non mechanic. If it is a selector, these things confuse the ...

12 years ago
Reply

Originally Posted By: Silly They installed an actual flexible tube, just like the typical tubes for our jacks. When the water returns it makes locatin...

12 years ago
Reply

This picture shows to me that the water is seeping in via a breakdown of the mortar immediately below the top of the pit light and also potentially ot...

12 years ago
Page 14 / 38
Scroll to Top