Elevator Forum

I'm pretty sure those have 2 contactors. They are both picking and in good shape? 109 is position for 77N/U and 83 is position loss in general. Motor ...

Are you getting a fault on the drive screen? Does the LCE side give you a specific drive fault? What Yaskawa model?

20 is no DPP 96 and 97 could also be DPP related.I'd start at the tape. If that looks good trap for the 20 25 combination to replay it back 1 frame at...

Sounds like you lost the shaft learn on the original. If it showed more floors than you have. You would need to do a shaft setup and the roll call sho...

Last time I had something close to that CLC had to be changed

Yes the switch goes through the HAS board. Verify the fire service parameter to be sure it's functioning

Usually just components for reliability. Try extending the learn past the stop command. Ignore stop and hold the run until done

Yes both point to channel 1. Is it a repaired or new board?

Sure

Then I'd suspect suspect the bar reader but you could do a shaft learn 5-2-1 and see if that clears it up

Does this unit have cigar switches for DZ? If it does start there

PM sent

Is DZ changing in MR? Light should flicker. If not check traveller otherwise I'd start with an Adon board. Sometimes if you give a few good taps on th...

Yes. Looks like you can even Google the manual for it

Unplug the battery if you leave the line out or it will go dead again. Some very old software won't have the option to bypass a dead battery