Elevator Forum

Why is your company looking after equipment they can't provide testing procedures for?

it's interesting to watch the progression over the years. the HPLIM door locks eventually became the NG door locks that most Gen2s use today. this was...

is the PLC battery dead?

How can you look after equipment with no prints? this seems like a them problem not a you problem. if they can't locate/buy prints they should give yo...

have you tried looking at the prints?

Originally Posted by EElevator Gen 2s dont have mlb3 boards. Thats a 411. Gen 2s are GCS boards. Early gen2s definitely use MLB3 boards with OVF30 dr...

Originally Posted by Bowtiedrooster16 The company likes it cuz you can order the hydro mods as a package with the controller already mounted to the ta...

you are allowed to strike the buffer during ETS/ETSL..where i work we try to setup it up so the car stops in the door zone, but this is not a code req...

wurtec sells them

copy parameter chip onto a new chip. software version is too old, need AAJ or newer.

Originally Posted by lowoil Sorry my bad, yes definitely need the kit so you don't wreck a packing during install. But I've had bad luck with TK packi...

thank you for the replies, this is the kind of feedback I was looking for. sounds like they work but probably best to stick with the 77 for simplicity...

I am not talking about the sealshttps://verticalxpress.com/tool-kit-three-stage-telescopic-jack-1150al.html Last edited by tayto; 08/10/25 05:06 PM...