Elevator Forum

Flossing the sandpaper over the drum didn't work out too great. It would probably be OK for smaller linings (these are 4.250x7.5") but on these one it...

If you don't use the seal installation tool you will damage the seals as you install them. i have had limited success with using projector sheets, but...

Do you have prints for the job?

UCM & door lock monitoring was all required in Canada starting in the early 90s. have you ever seen a sheave jammer before? not the most eloquent ...

Originally Posted by ashley Determine you piston diameter Then determine your piston area by Pie Times Radius Squared. Piston Area = 3.1416*((Piston D...

ERO is a European term, closest thing we have tothat equipment in NA is Spec 60s which was almost 40 years ago now. I've worked on a handful of marine...

Do you know who is running this?

Otis had a Bluetooth dongle almost 20 years ago. then went to a wifi dongle and now back to corded. That should probably tell you something....

do you know what the OMU is for?

judging from his instagram and youtube, this guy is an enthusiast not a mechanic.

I would get an engineer to preform a traction calculation. You will most likely need to weigh the cars & cwts to do this properly. At Otis Lang la...

Does this job have card readers at the hall stations?

Swap running car E2 into the GECB from bad car. Not surprised IO board is fine, still sounds like a parameter or IO to me. it will be difficult to fig...