Elevator Forum

Thegoat2....you go through big K to get the license? I have tried, but they tell me no. Do have the tools, but of course, not much good without the so...

Thanks. BTR16...IDWT suggested also, to block the MLT and pull the wire from coil of PM then we can check where we are getting the voltage from. Will ...

Posted the picture of the circuit of the print. In the up direction, if a door is opened it will change from high speed to level speed and stop at the...

Have print at job site, I thought the dwg was the wd. Will get it tomorrow and post

almost afraid to post this.....we were missing three suppressors. It has been doing fine since the replacement of the suppressors. Thanks as always ID...

Yep, that is exactly what we have had to do before also.

It actually turned out to be the motor, we did get a new drive and crazy that they sent us the Nexus drive to replace the existing. We didnt have the ...

Mad,(dmg) is what PTL use and TKE used to use(not sure if the newer elevators still do or not) It is what we keep in stock and use in just about every...

We used Motion Industries a few years back. They will need to know the size of the chain and can provide an adapter. I wish I could remember the chain...

Turn off door disconnect at IOE BOARDSet 061 to 1Set M13 to 60

In the 2K range. Available today, in the elevator world magazine this month also.