Elevator Forum

Are you getting run signal and is the brake lifting when you try to run on inspection?Are you getting direction relays picking?Need to know why car wo...

Low oil or MLT fault

Also check low pressure switch might be open T41 to P2 is safety circuitPM me if you need any info

Is it a roped hydro?Propaply a slack cable switch or just push contactors in to run up Then after safety is reset use toggle switch and click down to ...

Found loose plug insert factory wiring for pins on the main I/O board for main contactor auxiliaries

It’s a galaxy 3 just seen a don input off fault to

I wired in relay and it did not drop out when it happen I was not in site but contactor was still in.Drive cable is ran by itself Gal said to jump car...

Common to bypass Read the schematic

Having a issue with a duplex latching ghost hall calls Seen it one time Customer reports that the 1st floor hall call will just lath he bu itself and ...

Outputs o46 and o 49 energize TU and UD it’s done from opto couplers on the board. Try changing chip on board Last edited by Snkrhead; 12/02/18 08...

Send me your email I have some stuff

Anyone have a Manuel for start sequence for a soft start on a northern controller TC 181

No it's not clipping door lock.It won't go in high speed in down direction either at top fl