Elevator Forum

Yes of course !!!!

Got it ! Actually removed the hoistway wiring from board and jumped the door locks and the gate Got it down and boom door rollers were bent Fixed and ...

Check your preference selector contacts the UC relay is most likely staying in because of contacts on UC or DC

No you can’t it will fault out I believe if you jump the door locks and gate JJR nice idea but not for me 😂 Plus it’s the only car for that riise if s...

Please Read the reply! can’t access the cab because I can’t open door because of restrictor is attached and the hoistway doors can’t open or close Onl...

Gen 2 have a retracting clutch where you can’t separate doors , the car is at top floor, the release roller got jammed between the outside of clutch s...

It was the CPU board was bad that holds the memory of the positioning of car and the learn of hoistway Last edited by Snkrhead; 05/31/22 10:42 PM.

We are going to try to swap out the encoderWill keep u postedDid notice some play in the slide guides will take a look at that also thanks no switches...

Not always a empty car this is a old car I would say from 2008 no changes to car at all Last edited by Snkrhead; 01/30/22 07:42 PM.

Already did learn multiple times still happening Always in pit on final Sent board out multiple times You think software issue?

The A contactor is energized sending 120vac to the opto- coupler on the hyd 9806 board which converts 120vac to 24vdcThe signal is then sent to input ...

Make sure there is NO GAP between s/d magnet and DTL magnet on back of tape.Check tape guides