Elevator Forum

I did have a couple issues with the bootleg tool myself.The company I worked for had one from the guy who passed away.I found it worked very well on I...

I really don't know what you are referring to as a learn run? Goldflight is relay based logic with analog solid state speed control.

I do find the GAL product very easy to work on. I am very good with MCE stuff but I do admit that their tech support is a royal pain in the ass. Mostl...

not sure of your model assuming GDC . Check if RB relay is up.depending on the speed of the car you will have either P-limits, J-limits or K-limits. K...

The problem turned out to be a faulty LCR contact. Another example of an error code leading one in the wrong direction.

These cars have the remote relays.

Sorry a quick correction.The door gate relay is actually GDS.This problem occurs on inspect as well as normal. The route mechanic did swap the LCMLB w...

I have worked quite a bit on both Galaxy and MCE. Each new Galaxy I see has about 20 new parameters.So they are constantly adding new features. They a...

This seems to be problem on some Futura controllers. I have the same issue on one job minus the Fire service condition. Many times you will walk into ...

I would on all the Futura stuff for any of you guys that have quite a bit recommend finding any relevant copies of the current flash and parameter fil...

I also use it to get rid of bs faults appearing usually like 141-145 ETS switch not making up exactly where it broke type stuff.I don't recommend it f...

No faults.. I haven't been back there in awhile since it is just a job I was asked to assist on. The company trying to replace the 188E board didn't h...

Is this a LS-Quad or the Qute leveling unit? In either case it could be faulty reed sensors. I have seen on the LS-quad which uses and optical sensor ...