Elevator Forum

Did the guys perform a self tune on the drive during installation?

Schindler used to deliberately leave a few rather stupid drive settings out on new drives just to make having Cadi a necessity to getting a new drive ...

The biggest regular issue with 400A are the brakes and brake micro switches.The newer Mayr brakes are the answer to that problem but getting them will...

Brake switch

Thanks guys

Did you try swapping the interface board?The board beside the timer board. I had a similar problem on a miprom a few months ago. Actually it was due t...

Had this problem about 8 months ago. Surprisingly enough it turned out to be a door lock problem at the top floor. This is of course a quite different...

Ibox should be the ticket. They make a high speed version of their rail mount encoders with bigger rollers and a heavier spring.

I have seen this occur V2V pulses M1 precharge relay empty car deceleration into the top floor. Older VL cards needed new caps

Ralph I found out that their flash on Merida also can have more than one configuration available. I had a new CCU from them set up for one 8 stop unit...

You guys weren't even close.Try Serge relay controllersHaughton GAC1Cvt 8800 full control ie Thames ValleyWorld ClassOtis MRV