Elevator Forum

I'm with John jay on this one. At least try and tighten the belts before going for an encoder.

Yes ethics, as in the thought of making all information freely available, means that same information can and will be freely abused. If some building ...

No, I mean reloading the job image on IMS. Basically the I/O layout can be altered. So, let's say this was not ordered with security from factory, and...

Did you reload your I/O map for car or group when you reloaded the job .cfg? The original may not have had security I/Os on it, yet your laptop has th...

DLT should be on the prints, like around 132 or so in the string. We used a jumper to do stop ring tests, but I would need to be sitting in front of i...

Reason I asked is the sensor fault is sometimes the leveling sensors on the telescopics, though I do not think its the 1070. 1070 is most often, gaps ...

Yes I believe it's the main board, and sorry I still don't have an it's manual...if you have a specific question hit me up. Got me thinking, sensor fa...

Straight swap, if all 9's sounds like it lost itself. Might be worth trying to re scan the hoistway before swapping boards. There are two of them by t...

Elm hit it. Weak magnets are murder on all the TAC equipment that uses them. If the logs show any sort of pattern, try switching magnets around.

RCD, how are you going to open the shut off in the pit, that is in the closed position, with the car at lowest landing?Cutting through the floor, or g...

What amp fuse is it? Is the floor that is blowing your main fire landing? What voltage is your power supply throwing out at the controller? 24.5-25.5 ...

Construction, 15 years.... Hate customers that expect me to fix their piss poor scheduling. Get me in to start working, and expect an inspection 4 day...

Yes Elm, unless the micro switch is bad on the board, MDO and MDC typically work even with bad comm. the exceptions for this are, software, and board ...

Communication has 0 to do with the brushes. CAN com is to the UDC card only, regardless of brush, motor, or encoder conditions. Check for 60 Ohms acro...

Not all TAC 20 or 32s come with viscosity. Was an owners option and was value engineered out a lot from 2007-2010. Would explain why car is in the pit...