Elevator Forum

Check the software version so you have the right codes for that version!

Don't rule out Travel Cable either! Check it if always happens at same spot.

Pcc-10 cards are hard to find anymore. This will work in place of it.https://www.ebay.com/p/1008143072?iid=312799140457Opps sorry you need a newer IMS...

Might not be a bad idea to change D26=1 then change back to D26=0 since you loaded new software into board. Since you had D32 at 0 no telling what cou...

Is there any faults in car with IMS? Also check group.

PM me an email will send you what I have!

Anytime on a hydro you have strange intermittent issues, check the supressors or snubbers around the valve coils are there and/or replace or add.

I believe the Schindler HHT works very well by Dover. One of Dover NTS tools. Last edited by Rolly; 10/01/19 02:03 AM.

I have a 6719A. Will look in old Maintenance Books for a C. Will be tomorrow though. If you want what I have, PM me an email.

What is the controller type or a pic of controller?

Exactly right Len. The talent pool is getting smaller and smaller and cannot see the picture of what's going on. Lord help them if a button they are i...

May be running fine for years, so check the travel cables. Maybe Florida Flicker and Flash got it. Last edited by Rolly; 09/12/19 06:06 PM.

Change the RBI Board in Machine Room. Lot of problems with those boards.

I have to assume that when you change any of the settings like F16 you are doing a WRT after a change? Try changing F16 to no fire svc and see if the ...

No wiring diagram number posted so, not sure if this job has Leveling 6098 Mechanical Switches or sensors for floor level?