Elevator Forum

I don't have to watch the video to know your stupid enough to plug a tool into the wrong elevator. Better get lots of written procedures with that blu...

Your an Idiot! Change your name to DuhProm! You Just don't know how. Your one of those that needs a written procedure to wipe their ass. And I know so...

Good Lord! You can make yourself up a box to do all the things that a tool will do and complete a test. Kone has them available in spares to employees...

Bill Hempel, we all know that it can be done with a tool but you can energize the Gov Reset Solonoid WITHOUT a tool and reset the Gov.

Ok then post a wiring diagram number and maybe you can get a set of prints. Asking for terminals to use is absurd without knowing wiring diagram numbe...

If you don't have a print you do not belong working on that equipment. After watching the video of what happened in NYC I would stress this.levator-at...

Duh! Read the print..

Guys, the service tool just turns on an output to energize a solenoid to reset Gov. You can do it with a jumper.

I know of no fault 1027 on a Merida. You sure this is not an error 10, and error 27 or some specific type of drive error? Last edited by Rolly; 08/...

The Slim Line relays used on a controller will have an "S" at the end of the diagram number which stands for slim line relays.

Controller tag info? Wiring diagram etc?

It exists. The tool we used was the Console program to go deep into Kone LCE and Drives. Very hard to use. Not much about Kone is user friendly. Part ...

Also you know you can use a fluke meter on Hz to see if you have communication across data lines. Think it was 1200 or 1800 Hz.

sent

Have an email to send a TIP Article too? Last edited by Rolly; 08/02/19 12:58 PM.