Elevator Forum

Have you tried removing the metal plate on the backside and examining the circuit board?

Take off the metal plate and see if you can find any further markings on the circuit board. The design of the plastic front looks a lot like Innovatio...

Those jumpers do not look normal and are probably there to compensate for other issues. I've seen repair facilities put them on the backside of the bo...

Can you upload a picture?

You can probably rid yourself entirely of Kone for a little bit more money and find someone who can fit something else into your hoistway.

I had a blown fuse on the board in the machine room that made the hall calls and fire service do strange things when you tried to register a call.Are ...

Is the second floor the alternate landing for fire service?

Try ECI also.

When does it make the noise... during acceleration, high speed, transition, and/or leveling? Does it only growl at upper landings when the oil level i...

From the article:"One elevator door was pushed open with such force that the door came off its bottom tracks and was bent inward into the shaft, the d...

So you're saying that the car never overshoots the third floor otherwise. What if you turn the power off and back on again, then run the car to the th...

The local news here said that the car was on the second floor and the woman was on the fourth floor and went through the open hoistway doors and fell ...

You could just have a bad input chip, but my fear is "the smell" you described probably fried the socket as well. You'll likely have to either swap th...

Elevator Controls Corp makes a decent controller also, similar to MCE.

Some of those pushbutton boards have a jumper (or diode like E-man said) on them that may need to be removed, so compare the new board to the old boar...