Elevator Forum

thnks for youre answer !!!has been use in the USA ?is no change in Software protocol USA or Europe ?

Originally Posted By: ThyssenKrapp Go for it!These units are ok once you get used to them, all spares are available to anyone in Europe Buy a Modutool...

The MHC has a Jumper ABCthe Jumper musbe in AB position all the Time

wellfor door disable, go to menu found "Special Trip" next KFM tourn in ON with KFM car run with door disablepress button 1 & 2 to return to Statu...

1209 is not a Extra info should another fault 1209=Missing NOde (something in comunication)or power filure in LON sometimes has 24v in controller and ...

No extra Extra info ?

f4 is a new board version of f3 (rihgt now is f5) is same drawing 9300 maybe add 1 or 2 new fault that all Last edited by NOTIME; 05/25/16 12:05 PM...

im goint to remove the Link try as soons as you can

Schimdler recomendation is remplaces all at the same time white the Samll boards over the IGBT, when money is important we change in pair normaly use ...

re adjust the drive MCE must to calibrate some parameter before run the car (check isolation transformer taps )

well if you realy isolate the Smoke sensors the reset signal is the first input in the first Hall board, normalyy is Bypass and the cars go to run whe...

couple of years ago i recive a IMS frome there , send a Email ask for a phone # i remember been call , talk and resolve some laptopsconfiguration prob...

normaly TKE jacks use a a valve inside each jack section , when you has lot of SYNC problems must to remplace , (this valve are inse the jack must to ...

is a ICON or is a tac 20 ?