Elevator Forum

if you have the Samll AC Drive inside the COP, you Need the remote tool is the only way

9300 Unit normally lost the Bell when the Roller are Dirtmust to remove and clean each Line mustbe cleaneor other problem couldbe a Roller base in Ben...

when This happenmust to check the Status in HandHeld check wiring to Softstater somthing in the RMH board is all time active (logic BAD RELAY ) Las...

Check the MOtion Info all Screen maibe is not a Fault is just a Status Somithing activated "earthquake" Loadweight" etc......

Originally Posted By: Chris I am looking for any adjustment procedures, prints or manuals for a MAC PMSSC-SL Door operator and any info or prints on t...

wath do you need ?

Check jumper in MPT first car an last car has difrent config than midle car

i cant remember the times but if MPH 2 relevel 3 or 4 time in less than "xx" time without move from this floor, the computer move out of service you m...

couldbe a bad battery but before unter the battery has a jumper A B Cthe jumper must be in A B to maint info

wath do you need ?

1008:Motor Contactor Already Energized (MCD/MCE). Run initiation was issued, but either MCD was already inactiveor MCE was already active.S Defective ...

OLD Manual:New Manual: Last edited by NOTIME; 08/30/14 11:51 AM.

Check Traveling Cable check in the print the LONIO for the Landing systemcheck the landing system

if the car has (N) in the display is in Normal, and if this problem happen you must to remplace the software maybe this version has a minor bugquestio...

any failure, or status in display ?