Elevator Forum

Thanks for the update, it'll seem like nobody replies on the fix here.

And you metered dcl?

Could a IN or TA, why don't you send a picture of the whole controller with all the relays?

Lp also

Is there a rear opening? Easy enough to check the diodes with your meter.

Which fuses? Did you check to see if you have 300vdc coming from the rectifier for doors before. Fuse 5&6 i believe feed.

Check the lom pin on the power card to 0 volts when normal. If that changes when faulted then its on low oil. What type of valve?

Make sure your open and close limit bands are tight and not broken.

Did you try TECC?

1062 can be caused by a gap in your slowdown magnets. I've replaced several door motors now and had 1040,41,49 faults. Or try the door open limit?

Probably a door motor

Possibly z3a z3b switch, at least this is the problem I had awhile back with one of these. It wouldn't open the door.

Should be the roller switch when it comes to the floor to bring in door zone.

What is your 5vdc at in the cop?

Superpro model 280u xeltek