Elevator Forum

lowoil
@lowoil
Reputable Member
Joined: Jan 1, 2010
Topics: 10 / Replies: 260
Reply

What values for initial installation? Maybe you shouldn't go bragging on "substack" about how AI fixed your elevator. Everyone i know can't fn stand t...

6 months ago
Reply

Either it's bad, mounted too close, or try switching rx and tx. Six inch point adjustment?

6 months ago
Reply

That could be a kieckhefer probably.

8 months ago
Reply

Adams

9 months ago
Reply

I heard back in the day otis had cj building some of the solid slate controllers. That's how I found some of my coppers and carbons. Even the bronze c...

9 months ago
Reply

If you have the contactors, ohm all of them out carefully because they will fail over time.

9 months ago
Reply

Have you checked 7-70 your top floor access #?. I had this change to 0 b4 by itself and an inspector came out and wrote it up. Wouldn't work.

9 months ago
Reply

You didn't mention the operator type.

10 months ago
Reply

Write protect off

10 months ago
Reply

Slip it works great for wood rails. Never tried anything else.

11 months ago
Reply

Ones that I prayed for many times!

12 months ago
Reply

Adjustment 18 001= front and rear doors J2 jumper on rear door board all others off

1 year ago
Reply

$55 a month for tk contract customers non contract idk. Otherwise get your pots line back lol

1 year ago
Reply

Max link subscribed through Tk cellphone.

1 year ago
Reply

I use the hand held tool to set mine and you have to compensate for the tank lid also.

1 year ago
Page 1 / 18
Scroll to Top