Elevator Forum

Do you get inputs for bucher up or down level? Del Con fault or run and direction? First thing I check always is zero point on these things. Two scree...

TFR RRF

What I've seen with wcr jobs is you need to meter the contacts and not just replace relays because the bases have issues also.

I've seen this on 211s when the hall button board goes bad but only stays lit on that specific floor.

Kone works on Lon. There were issues years ago with travelers being installed backwards and causing breaks in wire.

I see this sometimes when there is too much magnet and I'll trim half off. Up fast monitoring and tsr1&2 need a little room.

It would be on a second option board.

How about 1a for bottom floor selection, DC cancels down calls but it sounds like your intermediate floor is working. Do you have 1ua or os? Is it car...

Sorry my bad, yes definitely need the kit so you don't wreck a packing during install. But I've had bad luck with TK packings and we switched to Gorma...

Absolutely not, Gorman is the best option.

Looks like it's from a Dover DC62 operator

So when I had an issue with rtr the car was in the safeties and my rope monitor device was on the fritz causing my relay to pick and drop. The phone i...

Zero point set?

Did you replace the delcon board?

SMC= set mac call number