Elevator Forum

317 is your pulse cont is off and needs a relearn probably. 313 did reach door open limit.

I have a chip programmer in my van for years but I don't know how to use it.

Sees sells the strikers if that's what your looking for.

On a solid state it's the power card, lom is the terminal to read

Should be a timer,possibly the type with a dial on the front. 1low oil relay. If so is it picked? Does it stall in leveling? I've had bad timers on wi...

You can plug your IMS into the door operator while running upon inspection and check your I/Os buy swipe a magnet past the sensor. Sometimes plugging ...

Do a wjr to see why and how many times. It's syncing. Is it static or dynamic?

Could be a bad door motor?

I have one with battery lowering and when I do the cat 1 test it doesn't require a double reboot. I pull the hook, jump the aux contact and it lowers....

I found a mouse jamed up in a gal interlock box once, wasn't getting my door circuit. Boy did I jump back when I saw that thing in there.

Just went down this road not too long ago, ended up being the optocoupler on the crip board. This was a 321 tho but same fault.

Logic master hydro counts by the hoistway switches.i would start there.

Just went through a number of problems on with not canceling an up hall call,opening the front door on the rear floor, and door open timer bad. Had to...

Dummy