Elevator Forum

You can try pulling the switch and see what happens. However if everything is running good, it may be best to keep on wondering. Wondering never hurts...

it could be one of the slow down switch's at the bottom floor

Sorry, I spelled College wrong. This person's Dissertation is a disjointed uninformative mess. I purpose we quit clicking on any of his tutorials. If ...

You should look closely at the Main and E Brakes. The Main Brake may not be holding the floor before the E Brake times and drops. Load weighing, Balan...

Wow, you need to show this to your collage professor.You may get an A+

This was thoroughly discussed. Go to threads, look up eco disc, big clanking noise.

you should consider writing speech's for politicians

Try adding some tape to the top and bottom of the leveling magnets where they end. I had a similar problem and the metal the Magnets were fastened to ...

You may have a cord on the Lambda breaking intermittently. When it happens does the controller show the edge as the culprit?

do you have a service tool or diagnostic software?

you probably have to have it rewound at a motor shop.if you need a print PM me.

I totally agree Koneisland,properly setup they are not heard outside of the hoistway by the general public. An elevator mechanic may hear a soft clunk...

Unfortunately that is the normal sound of the Brake when it is out of adjustment. If adjusted properly they make a soft clunk not heard out of the hoi...

I had an issue like this with an MPH2, I remember the issue was exactly the same. It ended up being a timer that had something to do with the oil heat...

It is fairly easy to check if the car is moving when it try's to heat the oil. This is also the likely culprit, unless the low oil time is too short. ...