Notifications
Clear all
Topic starter
06/01/2017 11:47 pm
Hi , i have group of 6 car.
All 6 have the same Lambda 3d Door Detector.
All 6 are set the same on the Dip Switch.
All 6 have the same Lambda 3d Door Detector.
All 6 are set the same on the Dip Switch.
Only the Elevator #3 , Close his Door by force after 15sec instead of keeping it always open like the other one.
https://www.facebook.com/photo.php?fbid=...e=3&theater
I posted the picture of the board and the cover on my facebook page, if anyone want to take a look.
The Door Operator is a MOVFR from G.A.L
Thank you !!!
Topic starter
06/01/2017 11:55 pm
Actually, i have to say.
When the client said to me about the #3 elevator, i took a look, and i compare the Lambda with the other,
On the Well-Working Door, the dip switch #6 was on the opposite of all other switch *( Just like on the picture )
And the Fault Elevator, was all on the same side.
So i did switch it, and , it seem to work well for 2 week, and now he called me back to said that, the door is still closing after 15second, and the dip switch is still as a left it !
When the client said to me about the #3 elevator, i took a look, and i compare the Lambda with the other,
On the Well-Working Door, the dip switch #6 was on the opposite of all other switch *( Just like on the picture )
And the Fault Elevator, was all on the same side.
So i did switch it, and , it seem to work well for 2 week, and now he called me back to said that, the door is still closing after 15second, and the dip switch is still as a left it !
Is the board Screw-top ?
Or is another option ins the Door Operator it self ?
06/01/2017 11:57 pm
Sounds like the problem may not be the Lambda. Does the Lambda reverse the doors when on normal? What kind of controller do you have. Info from the Controller Data Tag.
Topic starter
07/01/2017 12:17 am
yes its does reverse, it's work well....
the controler is --Otis Elevonic 411m--
the controler is --Otis Elevonic 411m--
07/01/2017 2:09 am
You may have a cord on the Lambda breaking intermittently. When it happens does the controller show the edge as the culprit?
Topic starter
07/01/2017 2:12 am
Hum, i can't say...pretty hard to check that alone
07/01/2017 3:44 am
maybe this car has nudging enabled, and the other cars do not. check that out. you can always disable nudging, and when the problem happens, the doors should not close, at least you can experiment with this. turn off nudging, and block detector edge, i believe the pi should start flashing when nudging time expires, but doors should not close with nudging disabled. ocss car features 3-16 disable nudging.
07/01/2017 7:33 am
did you turn off power to lambda after flipping dip switch also check car station for stuck button i have had button issue do same thing an not light call
Topic starter
11/01/2017 3:55 am
yeah , i did power off/on the lambda unite.
I still didnt check about the nudging, that is the next step.
Thank guy, ill give news about that