Elevator Forum

I have similar issue and it turned out to be that the factory installed fast acting instead of slow blow/time delay fuses

I think device is defective. It would give a 0146 if it was just a dead battery.

It turned out to be cold solder joints at the s door relay coil

Magnetek drive? How close is your tach cable conduit run to high voltage wires? Are there big ass radio,microwave, cell tower, etc stuff on the roof o...

Not sure, but try disconnecting selector and door board and see

If I remember right ,I've had comm problems before and after adjusting my 5volts from 4.9 to 5.1 I was able to fix problem. I've also recently had a c...

Check power supply voltages behind cop

Something is probably wrong with a slowdown signal coming from the selector micro card.

What kind of program, ims? What version?

There is but it probably never got hooked up. Just took the job off Kone so I'll check that next time I'm out there. Thanks

I made it out there and the unit was tripping the governor switch because the rails were dry causing it to bounce especially while leveling into the 1...

What position is jp5 jumper on? That changes communication type, 485 or can.

Thanks, will do first thing Monday