Elevator Forum

I'd like to meet the Schindler engineer whin thought that was a good idea. Hopefully we will be somewhere where nobody can hear him scream.

Schindler inverted telescopic jacks. Just did another packing change on one monday that blew out, big mess.

Than I don't have what your looking for.

I've got prints for a hydro from 1984 that says "up leveling, down leveling, and door zone sensing units". Do you think the "sensing units" AR the mag...

My open limit changes states properly, that's one of the first inputs I checked. If I remember right the other car has upb and dpb so I'll check those...

It wasn't the PIO board. I now know the unit works fine if it's at the top floor or in the down direction. It just keeps the doors open when it's at t...

12-1S756144 (not sure if last 2 digits are 4's , the stamping wasn't done that good)

That might be close enough. I'll pm you.my email. Thanks in advance

Pc version

I have the world tool and it does change the labels. The only issue with their tool is the timing. You can tell that your working on a new laptop that...

Like indirt said, adjust your 4.7 up to 5.1 before you go any further. I recently had a 1000 doing some funny door stuff and when I plugged my tool in...

I had the same issue on a tac32. I reloaded software off the flash drive in the controller and the problem went away.