Elevator Forum

Do I just press select/accept button again once I'm looking at the fault to get the subcode?

I didn't check subcode but will tmrw. For some reason I always forget those until after I've cleared faults. I'll also check rubber tire.

Does this epoch use optical sensors and reflective tape for leveling? I had some epochs with leveling issues, I replaced the reflective tape and the i...

It was the 360 board

Thanks. I'm getting some overnighted.

This issue isn't intermittent. When unit is on any floor but the top, I reset cpu with controller on inspection, and but it on auto, it goes into fatl...

Less than a day

I've done it on a miprom with an analog ab drive. The kit came with some metal bars that extend the controller cabinet so the new digital magnetek wil...

THANKS Rolly, but I have a lot on these including the troubleshooting manual, block diagrams, prints, Backplate charts and diagrams, etc. I really app...

Call doesn't cancel. When it relevels back into floor the doors open, close, and then it tries to run down again without having to register another ca...

Jkh, no I haven't but I'll see what happens when I do Monday morning. Elmcannic, I've checked leveling inductors all the way back to card slots but I ...

I've swapped all boards with ones from another controller that was working fine. I've also checked & cleaned contacts, Checked every inch of wirin...