Elevator Forum

I've got to figure out what it's seeing or not seeing when it's "between landings"? And it's more than likely something I wouldn't expect.

1a and ta seem fine especially their nc contacts. Another thing, if I jump out the slowdown it stop after coming off of, it will continue to run until...

S doesn't drop out but d does and the up relays pick the instant d drops. It's like something in the logic of the boards doesn't like what it sees (in...

Yes, my placement,gap,and spacing have all been correct. I've also tried adjusting the gap,and going in and out with my spacing , a little at a time a...

As its running the scan I'm sure it's logging a 118 fault at each floor. I noticed today that it had a 118 6010 at all floors but the 2nd where it had...

Drive is at the top.

I've got a v3f25 drive, I'm looking at it now. And it does have 61u,61n,and 30. The building maintenance guy said they've had leveling issues since it...

Thanks for the tips. I'll compare everything with the diagrams monday.

It's sub code 6010

The magnets for leveling and door zone are all doubled up, one on top of the other which doubles the magnetic field. I'm not sure why this was done th...

The magnets for leveling and door zone are all doubled up, one on top of the other which doubles the magnetic field. I'm not sure why this was done th...

I'm sure now I'm not able to learn the hoistway correctly. I keep getting an 01 18 error when I try. The guy before me had to replace one of the magne...

Thanks. It's a 480v. I also found out that these were custom made by lcr electronics for tk so I have to get them from tk.