Elevator Forum

You can turn the TCI Lock feature off. It's under MCSS install parameters. Change from a 1 to a 0. Last edited by Indirtwetrust; 07/23/17 05:00 PM.

Originally Posted By: Silly I'm gonna gamble on the resistance load being inaccurate. Tons of jobs got turned over early with improper loads. You shou...

Have you gone through all the terminations on that CAN channel? Are these 16 or 32 bit controllers? Are there repeaters on the risers? You should read...

That would be my guess too. Not sure if the logic board does the voltage measurement but I'm thinking not.

I replace the original Molex terminals with gold plated Trifurcon type. No more issues and you can still use the Molex plug housing. Just need to inve...

Is that the one that looks like the original PCD or the PC version?

I would go for the world tool before they only sell it on a tablet or something. I've never used the World version but it looks to be a copy of the or...

What does the starter say now? The way the Siemens starter was wired in is kind of a wild card. Most common reason for the motor wiring fault display ...

Well you either have a bad button or you're not getting HCIE to your button. You try putting a jumper across the contact on the button?

I think this should work. Keep in mind it isn't tested. If you don't want the starter to drop out when safe opens, pull control power from 4a instead ...

Maybe door hold input?

How far does it get? When the scan window is open, it should say Pass, Pass, then Fail at some point. What point? UNL is the last thing it needs to se...

Ya I'm pretty sure CETEK made the AC conversion before KONE offered one. I didn't know the DDC drive was "obsolete" until this week. I've heard of com...

No way! Maybe it's the climate. Does it ever get hot in NJ? Last edited by Indirtwetrust; 07/09/17 10:01 PM.

Oiling a chain with a Zoom Spout is pretty tedious. I'd go with a spray lube like TriFlow or a chain oil although I find chain oils to be awe fully st...