Elevator Forum

Is it AC or DC? Sure sounds like an MG set that needs to be compounded.

Bummer, I'll look at a print later today.

If it slows down but just keeps leveling right past the floor, it's probably a CS contact, I think it was CS1. Just had this issue a month ago.

Ya that's a problem. They just re-assigned fault codes for new equipment. I keep the most current help files in IMS and the old one on my desktop. I w...

So you can't get it to go slow enough to get below 7? The Kinetic is just a function of the speed and weight of the doors. If you are using one of tho...

Does your IMS work normally on another controller? If so, you may have a 188e problem and I would suggest reloading the software. If it's just your to...

Are you talking about stahl force or Kinetic? If it's an HD you could use a bigger diameter sheave on the motor. Is the generic r23? I just found r24 ...

I've never seen those responses from remote fast. What is the state of the I/Os on metered logic? OLTO sounds correct, the switch is closed, connectin...

Oh bummer, I see that now. There is 120 vac in the controller but you will have to add a 110 vdc "RUN" relay to switch the RUN input. Sorry about that...

1. That is exactly right, terminations on CPUA and CWI only.2. That sounds really high, that's from a brand new CPUA? I have replaced CPUA cards for l...

pull the brushes and check continuity from the brush holders. Those are A1/A2, the other 2 terminals are the field. Hook it up without worrying about ...

So they never showed more than a contact?Here's a pic of the board. First one I've seen with a board, only ones I've seen had the plug in amplifiers. ...

Have you replaced the WDPF PMI module?

Does it just show a switch in series with the relay coil? That's what all mine look like. Some say mag and some just say switch but I think an accurat...