Elevator Forum

The controller is in the hoistway? WTF? What state are you in again? So what do you have to work with, just a Service Panel Board mounted in a jamb or...

I am not an expert on these drives or anything but... Our tech support is pretty quick to say send in the drive when we start to get those faults. I d...

If it's intermittent I would go ahead and replace the module or the relays on it. I had one of those contacts flakey and it would only get holding vol...

Originally Posted By: Rolly I had one that would not run on inspection until I cleared all faults and logs with a svc tool. Worked fine then. You ca...

I'm not sure about that 12v supply, I thought it had to have it, must be wrong. I think you need to get Hyperterminal and plug in that way. But if you...

Hyperterminal is a terminal emulator program, it is free to download for Windows. It gives you a basic interface like just having remote fast. This is...

On the backplane, pins 1 & 2 are common. +5 vdc on 83 & 84 (2nd row from top). +12 vdc on 7 & 8 (4th row from bottom) -12 vdc on 79 & ...

What if you only have the CPU plugged in? Maybe your generic software is corrupted, does IMS work if you plug this new CPU in another car? So you have...

Have you tried to connect through Hyperterminal for a confidence test?

How are your power supply voltages?

Did you switch out the chips when you swapped CPUs? If not, car 2's CPU would still show up as car 2 in IMS even if it's plugged into car 3. I wouldn'...

Originally Posted By: Rolly Montgomery Kone WG Operator Thank you, what a POS!!I once fought with one for a month on an HS that that would drop SS i...

PMs sent at you

Originally Posted By: Snkrhead Car runs fine on automatic.Stops at every Hall call and car calls. Just when turn on fire service phase 1, if car is no...

I'm thinking CS isn't picking to initiate the slowdown because the DZ N/C contact #4.