Elevator Forum

Is the car always shut down at the same floor or at certain floors? I had a 211 shutting down on FLRP a couple of months ago. I caught the FS1 led in ...

The R24 generic software has a preset profile menu so just choose LH Linear DC profile, save to flash and give it a shot. I don't know if it doesn't a...

I don't remember but it hits the floors in both directions. Going through the floor calibration and setting all the offsets to 0 seemed to solve the p...

These cars did get the software upgrade about a year ago, they are gearless machines, GE. The thing is, I didn't convert the landing system. This was ...

You can set menu 5 parameter 14 to 22 to disable the battery supervision for 22 hours until you get a new battery.

The PPR was correct for that landing system. That was my first thought but even the top floor height was within an inch of the car next to it. I also ...

Try entering GET in Remote Fast

I never really believed in bad magnets until about 2 weeks ago I was getting FLRP faults on a 211, as you ran past that floor on inspection the LED wo...

Then you aren't getting a top directional limit. Look for the magnet on the back of the tape. (And it's the right side if you're looking from the fron...

What do you mean it gets to the top and keeps running? It should hit the top directional limit, stop, level down to floor level and status in IMS shou...

What fault #'s specifically are you getting?

And what is the advantage of that as opposed to turning the controller around 180 degrees and putting a closet right there? Besides the cost of a door...

That is a damn shame. And I thought the MRL hydros with the controller in the jamb was a bad idea. (Those aren't legal here either). Is it at the top ...

And clean or replace door lock contacts. Especially if they're ECI!