Elevator Forum

Ya, just looked at a print to make sure but the AMD operators are discreet to the CCBN board. 24vdc logic, open & close inputs, open & close l...

In Advanced LON Manager, select the correct channel, click Add Node, press the service pin for that channel on 188E. Last edited by Indirtwetrust; ...

Sounds like too much pre-torque gain

I should say that I am far from an expert on LON and don’t work on it very often. But that goes contrary to the way I think of LON working. While you ...

You won’t see the new LN in LON explorer until you delete the old one, add the new, find & bind with Advanced LON manager. You should be able to g...

What does it say if you put the old LN card back in?

It’s the TP/FT-10. The cable is the same one you use with the PCC-10 card. You just need a little adapter cable that goes from the funky 2 pin plug on...

Then it’s an 1150 and Z44 was too low

You can use an XE2 if that helps in your search.

I don’t think the IMS version should matter, there is an adjustment in settings for USB. I got a hold of one, download the driver of the internet, cha...

What part number is the brake regulator? Is this a modernization?

There is a USB LON-Talk adapter, I’d get that one so you’re not tied to an ancient laptop. Nothing against ancient laptops, mine still works fine, but...

It sounds like it does it every time so I would expect either the sensor is bad or something has moved. Hook up a meter to the sensor and wave the bea...

The dynamic sensors go straight back to the IOD, not related to your other faults. Do you have IMS to watch the inputs? TPDL and TPDR should come on v...

If you give some more info I’ll see if I have a close print. Passenger or freight? How many stops? Selective/collective? Does it say SPM on the contro...