Elevator Forum

I have low pressure switch

Originally Posted by Jluff CFS2 is blue and CFS1 is red HFS2 is redHFS1 is blue FSM is blueFSX is red Assuming red is high and blue is low, you have ...

Have you checked the status of CLC variables CFS1 & CFS2? CLC - Variable - 008 - CFS2 is bit 3, Phase 2 off, should be high. CFS1 is bit 4, Phase ...

The best next step to take would be going through the drive with TK’s “Universal Drive Tester” You remove the Amp Traps, power up the controller and s...

BTW, I have now seen Con 650 used but don’t have a print that shows it.

Add a delay on timer in the power supply to the CPU at XM16. Power fluctuations on power up or power loss will cause this. It’s recommended to pull XM...

With car 2 off, reload the group then make sure all the hall calls are in the group I/O map. When you enter a DHNF command you should see all the HNs ...

You could break up the circuit with in-line fuses but it would be a big PIA. Maybe if you had a couple RJ45 breakout boards or couplers. And you could...

As much as I agree that it sounds like a travel cable, I don’t see that P24M going through the traveler at all. Have you tried running with the buzzer...

I agree the first 3 are all V5 software bugs, the 2755 I’ve seen pop up for no reason at all or even not clear. I want to say the V5R0P cleared up tha...

Originally Posted by josevalera maybe this will help you, http://partsview.konespares.com/Details?id= 65658 The Hyperlink cut off the numbers at the ...

If the door didn’t close with the wire pulled it’s normally closed, I was thinking they were normally open. So to get the detector out of the equation...

Pretty sure it’s 485. The adapter TK uses requires it’s own power source. Is the software made by Montgomery?

So when I said see if the SE wire reads to ground, I meant check the resistance to ground. If all is well I would expect to see a reading in the high ...

If it still happens with the wire pulled, see if the SE wire reads to ground. Could be a short or bad edge detector board. If it doesn’t, I think I’d ...