Elevator Forum

Kone KCM LCECOB24 b...
 
Notifications
Clear all

Kone KCM LCECOB24 board (KM757650G11)

5 Posts
4 Users
0 Reactions
6,945 Views
 RobM
(@robm)
Active Member
Joined: 17 years ago
Posts: 3
Topic starter   [#24495]
Hello,

Having issues with a job randomly losing program, or program getting corrupted, on The LCECOB24 board in COP. Seems to happen after power outage or power being cycled. Get board reprogrammed and works for awhile. was wondering if anyone else has seen this and if they heard of long term solution.

Thanks for any assistance.

Rob



   
Quote
(@la-tech)
Eminent Member
Joined: 17 years ago
Posts: 27

   
ReplyQuote
(@indirtwetrust)
Noble Member
Joined: 17 years ago
Posts: 1759
 
Add a delay on timer in the power supply to the CPU at XM16. Power fluctuations on power up or power loss will cause this. It’s recommended to pull XM16 before turning on the disconnect, waiting 10 seconds or so and then plugging it in.



   
ReplyQuote
 RobM
(@robm)
Active Member
Joined: 17 years ago
Posts: 3
Topic starter  
The Chip is pulled from board and reprogramed and reinstalled in board. there is no component failure , just losses its program or gets corrupt.



   
ReplyQuote
(@upndwn)
Eminent Member
Joined: 17 years ago
Posts: 22
 
Indirt we trust is correct the inrush of power kills board. There is adelay off no delay on. Or just unplug xm16 before power down n up. But pins will eventually come loose



   
ReplyQuote
Share:
Scroll to Top