Elevator Forum

Brake Test. We don’t use it here.

In NA 6-30 should be set to 0. Check if 6-12 is a 1, set to 0 if so. 6-99 to 1 to save.

61U, 30, 77N, 77S on. 61N 77U off. I assume you have a running car on inspection. What mode is 4-1 when you take car off insp. while trying to do shaf...

Most likely everything I said does not apply. What machine do you have? If it is a green machine do the brakes set at the same time? Can you post a pi...

Is this in the USA?

Make sure the machine does not move after the main brake drops. There is going to be time between the main and the e-brake.

Are all three led’s illuminated on the eq board?

Columbia Elevator makes an adjustable bar that replaces the fixed hole position bar on the operator wheel to correct the issue that Indirtwetrust is t...

Motor leads U V W. Is W from the motor hooked to W on the drive?

Can you elaborate on reprogrammed. I have only seen these boards fail with 1301 fault.

5-7-1 Lon Download5-25-1 Adon Setup

Turn power offSlide switch on Adon to the leftPower on5-25 to 1Wat till it says run on insp then do so either direction until stop is displayed Power ...

Try clearing the faults. E-2-1. Leave the car on insp. Try to run on insp. What faults come up at that time. Are you getting the Ebrake cmd on the Ado...

It is an address issue. You can not address through the CPU.

The car buttons are programmed and the memory resides in the actual button and the MUL board. I is appernt that the 2nd floor button programmed the sa...