Elevator Forum

I’ve hat problems with Elevator Controls ribbon cables and their connections.

Make sure you use Gorman packing.

Should be the keyed run/stop switch in the car

to put a UIT on the controller you will have to to the factory and get new software. You can put a UIT on the door operator if it is one of the newer ...

Good job. I knew you could make it work.

It’s a TK (ITS) Troubleshooting tool. A board and software.

First type in SEA to see if it recognizes the adjustment. It may or may not depending on the software version. If it does, set it to 4, that should be...

On a different Big O note, I'm looking for TIP 31.4-6 about loadweighing. All the adjusting manuals refer to it for more information.

Wow! Did I win dumbest question of the month?

Rally: I didn't check the software version.Working Class: This is a newer 211, FLASH, no EEPROMsNewMech: I would swear I've changed parameters on a 21...

I'd take those Miprom 21s over a KCM or a Schindler anything!

I've never worked on a Miprom 21 that you had to do anything like that, unless its a permanent magnet motor that needs an encoder alignment. I have wo...

Looks like reduced speed is activated by giving an open and close command at the same time, pulling 16 & 17 low. But the operator does have a nudg...