Elevator Forum

I bet the SESBLNK input is just on

Wait, I read it again, where are you getting the comm fault and what exactly does it say? The IMC controller doesn’t communicate with the F5 drive. Do...

Try changing the motor type in LF4 to something else like PCLSd, then go to US10 and load that configuration, then put the correct motor type back, go...

I got a set of AC but I would love to get your DC prints too

You need to be on Positive Logic for a Tac50-04. Probably doesn’t have anything to do with why the car isn’t running.

Have you checked the magnets on the back of the tape?

Check the brushes, rigging, & connections

The DSP software should be OK, or at least I haven’t had to update it yet. But ya, all cars in the group will need the HE16, but it will work in the o...

Maybe replace with a soft start? What kind of controller? Is the motor itself seem standard?

No, you need HE16 software. Also make sure you don’t fire it up for the first time with your adjusted U22 chip or you will while it and have to adjust...

News to me if those are obsolete but if they are, the same circuit exists on the 6300JL4 CNWI board used on a Tac20. You could use that board. Assumin...

What fault?

I don’t mean that it sounds crazy or not correct. I mean it is physically impossible to connect +5 and -12 (or any other voltages) together and have t...