Elevator Forum

Notifications
Clear all

Tac 50-04

5 Posts
4 Users
0 Reactions
4,924 Views
(@upndn33)
Active Member
Joined: 17 years ago
Posts: 10
Topic starter   [#26185]
I’m getting an ntsd error as well as a ntsd clamping error.this is a mod which has a tape with the perforated holes any help would be great.i changed the board and it ran for a few hours but crapped out again.i also did a learn run



   
Quote
(@indirtwetrust)
Noble Member
Joined: 17 years ago
Posts: 1759

   
ReplyQuote
(@upndn33)
Active Member
Joined: 17 years ago
Posts: 10

   
ReplyQuote
(@elmcannic)
Honorable Member
Joined: 17 years ago
Posts: 635
 
By “checking the magnets” as IDWT suggested, did you look carefully to be sure there are no gaps at all between magnets, and are they glued in place?



   
ReplyQuote
(@whadafack)
Trusted Member
Joined: 17 years ago
Posts: 80
 
Do a tbs. adjust your decel before you do it. Bring it up while u do the scan then back down to its original settings



   
ReplyQuote
Share:
Scroll to Top