Elevator Forum

So I went out there this morning. The customer had put all 3 cars on independent on the 6th floor so they wouldn’t run all night. I sent them all down...

Did you replace all the slowdown magnets too or just the at floor magnets? Especially the slowdown magnets going into that floor the mechanic saw it o...

Is it always at the same floor? I have found a bad magnet on a 211.

If you don’t have the exact door weights, tell me the door height, type, opening width, and finish and I will find the time for reduced speed (2.5lb k...

How are you measuring the kinetic? The spring stick is incredibly inaccurate. If you are timing the doors, double check your door weights you are usin...

Most AC drives charge the DC buss through a resistance of some sort until it reaches a set voltage where the resistance is bypassed to fully charge th...

That version shouldn’t be a problem. You don’t need to order a 188E with software but if you buy a new one, you’re going to get a KY14 and it needs at...

I just got one a month or so ago. And another one maybe a year ago.

Have you tried find node, add node, replace node? And Host B never shows up? But Host A does?

Check the wiring between Con22 and the HCID. Comes in Con98. Maybe try plugging cable directly into Con22 and see if you can see the Host.

The 2407MC could absolutely be causing your problem. The voltage levels are the same as for channel 2 & 3. Also make sure all your contactors have...

Yea

Yep