Elevator Forum

You need to connect with Hyperterminal and do a confidence test to see what the problem is

This could make a little more sense with a Composite. You almost have to be picking CS to initiate a normal slowdown but unlike a WCR, CS does not dir...

Wait, this isn’t a traction car is it ? (composite). I assumed WCR hydro.

I’m struggling to see a way for the car to both make a normal slowdown & stop but not open the doors since the door open circuit obviously work. C...

Is it stepping correctly while doing this? Does it get to high speed before stopping at the next floor? And it does open the doors at the floor with t...

Does the car run normally on inspection?Is 61U coming on before 30?Are all your 77 switches in the correct state?Are you getting any other faults?

You want at least 2.7.16 or you can’t see door faults. Huge disadvantage. You would be better off with a 2.5.x (pre-tablet) version. Last edited by...

Hey that sounds like fun. Are you going to use a 10K drive? Is the motor going to drive a hoistway simulator or will the hoistway be virtual? I think ...

Not that this is what you want to hear but.. I think an elevator in that condition should be mod or nothing.

Door locks, gate?

Is the LED off again? You might consider replacing the 3 pole toggle switch and the LCC11 MTA connector.

It’s a Tac50-04. That’s the same as a 681 in IMS. Typically those are intermittent faults, usually related to grounding. It should clear with a power ...

To go to a JC5 you will have to upgrade the software of all cars in that group to HE16. The DSP should be fine and you don’t have to change any of the...

Only thing else I can think is the car moving too much in the guides at that floor or a bad traveler. If it’s that consistent even on inspect, I’d pro...

For a 69 I have Safety chain open ST2Contactor SL1, LZ, 487, DZ or ADOP not operating correctlyIs it a Bar reader?